Drive Motor for Forklift - MCC's or likewise known as Motor Control Centersare an assembly of one section or more which include a common power bus. These have been used in the vehicle business since the 1950's, for the reason that they were used lots of electric motors. Today, they are utilized in different industrial and commercial applications.
Inside factory assembly for motor starter; motor control centers are rather common technique. The MCC's include variable frequency drives, programmable controllers and metering. The MCC's are normally utilized in the electrical service entrance for a building. Motor control centers commonly are used for low voltage, 3-phase alternating current motors that vary from 230 volts to 600 volts. Medium voltage motor control centers are intended for big motors which range from 2300 volts to 15000 volts. These units use vacuum contractors for switching with separate compartments to be able to attain power control and switching.
In places where extremely corrosive or dusty methods are occurring, the motor control center may be established in a separate air-conditioned room. Typically the MCC would be situated on the factory floor close to the equipment it is controlling.
A MCC has one or more vertical metal cabinet sections with power bus and provisions for plug-in mounting of individual motor controllers. Smaller controllers may be unplugged from the cabinet so as to complete maintenance or testing, while very big controllers can be bolted in place. Each and every motor controller has a solid state motor controller or a contractor, overload relays to protect the motor, fuses or circuit breakers to be able to supply short-circuit protection as well as a disconnecting switch to be able to isolate the motor circuit. Separate connectors allow 3-phase power to enter the controller. The motor is wired to terminals located inside the controller. Motor control centers supply wire ways for field control and power cables.
Inside a motor control center, each motor controller could be specified with many different alternatives. Some of the options include: extra control terminal blocks, control switches, pilot lamps, separate control transformers, and numerous types of bi-metal and solid-state overload protection relays. They even comprise various classes of types of circuit breakers and power fuses.
Concerning the delivery of motor control centers, there are many alternatives for the customer. These can be delivered as an engineered assembly with a programmable controller together with internal control or with interlocking wiring to a central control terminal panel board. On the other hand, they could be provided set for the client to connect all field wiring.
MCC's generally sit on floors which are required to have a fire-resistance rating. Fire stops could be necessary for cables that penetrate fire-rated walls and floors.
Click to Download the pdf